The Impact of Drilling Operation Parameters on the Lost Circulation Problems for Oil and Gas Wells Based on Field Data
Article Sidebar
Main Article Content
Abstract
Lost circulation, the loss of drilling fluid into holes or fractures throughout the geological formations being drilled, is the most expensive problem encountered in drilling operations for oil and gas wells. It is known that when there is a loss of circulation during the drilling process, the operation activities are delayed or stopped for curing or treatment, resulting in extra time known as non-productive time (NPT). The NPT issues during the drilling operations are the most important priorities for planning any drilling program. Therefore, the lost circulation is one of the main problems which can control the NPT. To mitigate the lost circulation problems, an integrated investigation is necessarily needed for the main parameters which enhance/downgrade the rate of lost circulation.
Drilling through the Dammam and Hartha formation is typically accompanied with substantial nonproductive time due to severe and often entire drilling fluid losses. The majority of the curing this problem require time for preparation, placement or setting. In this research, a field study was carried out to investigate the effect of 6 drilling parameters on the rate of the lost circulation. The investigated parameters are the rate of penetration, weight on bit, stand pipe pressure, mud weight, flow rate, and the equivalent circulation density. Furthermore, the effect of lithology type on the lost circulation rate was clearly determined and correlated. In addition, a graphical representation of bit depth vs the real drilling time/date was constructed to compare the lossy wells vs non-lossy wells named frithogram. This study was based on field data for 350 wells drilled in Rumaila Oilfield, southern Iraq. The results of this study showed that if these six operating parameters are standard and controlled, the significance of lost circulation problems could be reduced. However, the main factors which are responsible for the lost circulation problems are lithology types, facies and/or diagenesis process, which mainly distinguish the carbonate formations.
Article Details
This work is licensed under a Creative Commons Attribution 4.0 International License.
Tikrit Journal of Pure Science is licensed under the Creative Commons Attribution 4.0 International License, which allows users to copy, create extracts, abstracts, and new works from the article, alter and revise the article, and make commercial use of the article (including reuse and/or resale of the article by commercial entities), provided the user gives appropriate credit (with a link to the formal publication through the relevant DOI), provides a link to the license, indicates if changes were made, and the licensor is not represented as endorsing the use made of the work. The authors hold the copyright for their published work on the Tikrit J. Pure Sci. website, while Tikrit J. Pure Sci. is responsible for appreciate citation of their work, which is released under CC-BY-4.0, enabling the unrestricted use, distribution, and reproduction of an article in any medium, provided that the original work is properly cited.
References
[1]Al-Hameedi, A.T.T.; Alkinani, H.H.; Dunn-Norman, S.; Flori, R.E.; Hilgedick, S.A.; Amer, A.S.; Alsaba, M.T., 2018. Using Machine Learning to Predict Lost Circulation in the Rumaila Field, Iraq. In Proceedings of the SPE191933-MS presented at SPE Asia Pacific Oil and Gas Conference and Exhibition, Brisbane, Australia, 23–25 October.
[2]Alsaba, M., Nygaard, R., 2014. “Lost Circulation Materials Capability of Sealing Wide Fractures” SPE-170285-MS SPE Deepwater Drilling and Completions Conference held in Galveston, Texas, USA, 10 –11 September 2014.
[3] M-I SWACO. Schlumberger., 2011. “Prevention and Control of Lost Circulation”.
[4] Haq, B. U., Hardenbole, J. and Vail, P.R., 1987. Chronology of fluctuation sea levels since the Triassic, Science, V.235, PP. 1156-1167.
[5] Jassim, S.Z., and Göff, J.C., 2006. Geology of Iraq. DOLIN, sro, distributed by Geological Society of London, 341.
[6]Ziegler, P.A., W. Cavazza, A.H.F. Robertson and S. Crasquin-Soleau 2001. (Eds.), Peri-Tethyan rift/wrench basins and passive margins (IGCP 369 results). Mémoires du Muséum National d’Histoire Naturelle, Paris, Peri-Tethys Mémoire 6Raad Z.
[7] Buday, T., 1980. The Regional Geology of lraq. 1: Stratigraphy and Palaeogeography. 1n: Directorate General for Geological Survey and Mineral Investigations, State Organisation for Minerals Library, Baghdad, Iraq, Dar-Al-Kutir publishing House, Baghdad, pp.445.
[8]Messenger, J. U., and McNiel, J. S. 1952. “Lost Circulation Corrective: Time-Setting Clay Cement”. Journal of Petroleum Technology, Vol. 4, pp. 59 –64. http://dx.doi.org/10.2118/148-G.
[9]Messenger, J. 1981. Lost Circulation. PennWell Corp., Tulsa.
[10] Morita, N., Black, A. D., and Fuh, G-F. 1990. “Theory of Lost Circulation Pressure”. SPE 20409, SPE Annual Technical Conference and Exhibition, New Orleans, Louisiana, USA, 23-26 September. http://dx.doi.org/10.2118/20409-MS.
[11] Fidan, E., Babadagli, T., and Kuru, E. 2004. “Use of Cement as Lost-Circulation Material: Best Practices”. PETSOC-2004-090, Canadian International Petroleum Conference, Calgary, Alberta, 8-10 June. http://dx.doi.org/10.2118/2004-090.
[12] Bruton, J. R., Ivan, C. D., and Heinz, T. J. 2001. “Lost Circulation Control: Evolving Techniques and Strategies to Reduce Downhole Mud Losses”. SPE 67735, SPE/IADC Drilling Conference, Amsterdam, The Netherlands, 27 February-1 March. http://dx.doi.org/10.2118/67735-MS.
[13] Bruton, J. R., Ivan, C. D., and Heinz, T. J. 2001. “Lost Circulation Control: Evolving Techniques and Strategies to Reduce Downhole Mud Losses”. SPE 67735, SPE/IADC Drilling Conference, Amsterdam, The Netherlands, 27 February-1 March. http://dx.doi.org/10.2118/67735-MS.
[14] Mata, F., and Veiga, M. 2004. “Crosslinked Cements Solve Lost Circulation Problems”. SPE 90496, SPE Annual Technical Conference and Exhibition, Houston, Texas, USA, 26-29 September. http://dx.doi.org/10.2118/90496-MS.
[15] Wang, H., Sweatman, R. E., Engelman, R. E., Deeg, W. F. J., and Whitfill, D. L. 2005. “The Key to Successfully Applying Today’s Lost Circulation Solutions”. SPE 95895, SPE Annual Technical Conference and Exhibition, Dallas, Texas, USA, 9-12 October. http://dx.doi.org/10.2118/95895-MS.
[16] Wang, H., Sweatman, R. E., Engelman, R., Deeg, W. F. J., Whitfill, D. L., Soliman, M. Y., and Towler, B. F. 2008. “Best Practice in Understanding and Managing Lost Circulation Challenges”. SPE Drilling & Completion, Vol. 23, pp. 168 –175. http://dx.doi.org/10.2118/95895-PA.
[17] Whitfill, D. L., and Wang, H. 2005. “Making Economic Decisions to Mitigate Lost Circulation”. SPE 95561, SPE Annual Technical Conference and Exhibition, Dallas, Texas, USA, 9-12 October. http://dx.doi.org/10.2118/95561-MS.
[18] Lecolier, E., Herzhaft, B., Rousseau, L., Neau, L., Quillien, B., and Kieffer, J. 2005. “Development of a Nanocomposite Gel for Lost Circulation Treatment”. SPE 94686, SPE European Formation Damage Conference, Sheveningen, The Netherlands, 25-27 May. http://dx.doi.org/10.2118/94686-MS.
[19] Bruton, J. R., Ivan, C. D., and Heinz, T. J. 2001. “Lost Circulation Control: Evolving Techniques and Strategies to Reduce Downhole Mud Losses”. SPE 67735, SPE/IADC Drilling Conference, Amsterdam, The Netherlands, 27 February-1 March. http://dx.doi.org/10.2118/67735-MS.
[20] Collins, N., Whitfill, D., Kharitonov, A., and Miller, M. 2010. “Comprehensive Approach to Severe Loss Circulation Problems in Russia”. SPE 135704, SPE Russian Oil and Gas Conference and Exhibition, Moscow, Russia, 26-28 October. http://dx.doi.org/10.2118/135704-MS.
[21] Qusay Abeed, Ralf Littke, Frank Strozyk and Anna K. Uffmann., 2013. GeoArabia, 2013, v. 18, no. 1, p. 179-200 Gulf PetroLink, Bahrain.
[22] Al-Mimar, H.S., Awadh, S.M., Al-Yaseri, A.A. and Yaseen, Z.M., 2018. Sedimentary units-layering system and depositional model of the carbonate Mishrif reservoir in Rumaila Oilfield, Southern Iraq. Modeling Earth Systems and Environment, 4(4), 1449-1465.
[23] Awadh, S.M., Al-Mimar, H.S. and Al-Yaseri, A.A., 2018. Salinity mapping model and brine chemistry of Mishrif reservoir in Basrah Oilfields, Southern Iraq. Arabian Journal of Geosciences, 11(18), 1-12.
[24] Awadh, S.M., Al-Mimar, H.S. and Yaseen, Z.M., 2021. Effect of Water Flooding on Oil Reservoir Permeability: Saturation Index Prediction Model for Giant Oil Reservoirs, Southern Iraq. Natural Resources Research, 1- 13.
[25] Stacker, 2022. The largest Oilfield in the world. https://stacker.com/stories/3860/largest-oil-fields-world.