Manufacturing of composite (Ni-Al +Al2O3-ZrO2) by using Flame Thermal Spray Technique.
Article Sidebar
Main Article Content
Abstract
Flame Thermal Spray technique was used to produce matrix composite of ZrO2 (25%) reinforced with Alumina (25%) with (Al-Ni) (50)% have been spray into base substrate of stainless steel type (316L). All samples were grit blasted as initial preparation state and all spraying done at different distances from substrate (12, 14, 16,17, 18, 20) cmtest of stiffness, porosity and adhesion has been experienced on the compound layer which produced to study the effect of changing the spraying distance on the layer characteristic. All samples were heated at (950, 1050) ºC for(1/2hr). The results before and after heat treatment show that the optimum condition for spraying distance at (16 cm) and heat treatment at (1050 ºC) which are most effective to give best results especially hardness, porosity and adherence bond.
Article Details
This work is licensed under a Creative Commons Attribution 4.0 International License.
Tikrit Journal of Pure Science is licensed under the Creative Commons Attribution 4.0 International License, which allows users to copy, create extracts, abstracts, and new works from the article, alter and revise the article, and make commercial use of the article (including reuse and/or resale of the article by commercial entities), provided the user gives appropriate credit (with a link to the formal publication through the relevant DOI), provides a link to the license, indicates if changes were made, and the licensor is not represented as endorsing the use made of the work. The authors hold the copyright for their published work on the Tikrit J. Pure Sci. website, while Tikrit J. Pure Sci. is responsible for appreciate citation of their work, which is released under CC-BY-4.0, enabling the unrestricted use, distribution, and reproduction of an article in any medium, provided that the original work is properly cited.
References
[1]: W. Bolton, "Engineering Materials Technology", 3'ed.,Butterworth-Heinemann, Oxford, (1998).
[2]: J.R. Vinson, T.W. Chou, “Composite Material and their use in Structure“, Applied Sciences publisher LTD, London, (2010).
[3]: L.F. Mondolfo,” Aluminum Alloys: structure and properties “ Butter worth com., London , (2011) .
[4]:O.sarikaya, “effect of some parameters on microstructure and hardness of alumina coating prepared by air plasma spray process ” ,Surface and coating Technology, Vol. 190, pp. (388- 393), (2005).
[5]: M.M Schwartz, “ composite Material, Hand Book “, Mc-Graw Hill, New York, (2006).